Digital Fields Board Differential Voltage Burst Waveform, Data

These data are pre-sorted by on-board competitive selection algorithms described in [3] before storage by FIELDS. A sub-set of this stored burst data is telemetered to Earth for scientist-selected regions of interest. The Level 2 data products contained in this data file have been calibrated for (i) DFB in-band gain, (ii) DFB analog filter gain/phase response, (iii) DFB digital filter phase response, and (iv) the search coil preamplifier gain/phase response (when applicable).

Calibrations for the FIELDS voltage sensor preamplifiers have not been implemented, as the preamplifier response is flat and equal to 1 through the DFB frequency range. Corrections for plasma sheath impedance gain and antenna effective length have not been applied to the voltage sensor data (these corrections will be applied in Level 3 DFB data), therefore units for all voltage sensor quantities are Volts. Units for all magnetic field quantities are nT.

The Level 2 data products contained in this data file are in sensor coordinates (e.g. dV12, dV34 for voltage measurements, and u,v,w for the search coil magnetometer). Time resolution for the DFB burst waveform data can vary by multiples of 2^N. During encounter (when PSP is within 0.25 AU of the Sun), cadence for the DFB burst waveform data is typically 150,000 samples/second. This rate is the sample rate of the ADC, and data taken at this rate do not pass through a digital filter.

References: 1. Fox, N.J., Velli, M.C., Bale, S.D. et al. Space Sci Rev (2016) 204: 7. doi.org/10.1007/s1121401502116 2. Bale, S.D., Goetz, K., Harvey, P.R. et al. Space Sci Rev (2016) 204: 49. doi.org/10.1007/s1121401602445 3.

Malaspina, D.M., Ergun, R.E., Bolton, M. et al. (2016) JGR Space Physics, 121, 5088-5096. doi.org/10.1002/2016JA022344